9,000 lb Overhead 2-Post Lift, 12 ft Open Floor | Atlas 9KOHX

Atlas 9KOHX 9,000 lb Overhead 2-Post Car Lift

If you’re outfitting a commercial shop or building out a serious home garage, you need a lift that handles everything from sedans to full-size trucks without compromising on clearance or safety. The Atlas 9KOHX is a true 9,000 lb capacity overhead two-post lift with a 12 ft tall open-floor design — no baseplate in the way, no restrictions on where you can roll your creeper.

The symmetric/asymmetric arm configuration means you’re not locked into one vehicle position. Low-profile cars sit right where they need to with a 4 1/2″ minimum arm height, and heavier trucks get the full support of 9,000 lbs of rated capacity.

What’s Included

• Atlas 9KOHX 2-Post Overhead Lift
• 8-piece truck adapter set (4x 1.5″ and 4x 5″)
• All mounting hardware

Made For

Built for shops and garages that work on a wide range of vehicles — from compact cars to full-size pickups and SUVs.

• Independent auto repair shops
• Dealership service departments
• Fleet maintenance facilities
• Serious home garages and hobby builders
• Body shops and detail centers

Features

• 9,000 lb capacity — handles cars, trucks, and SUVs
• Overhead open-floor design — no baseplate obstructions
• Symmetric/asymmetric arms — versatile vehicle positioning
• Dual direct-drive cylinders — fewer moving parts, longer service life
• Automatic arm restraints — single-point lock release for fast operation
• Powder coat finish — stands up to daily shop use

Symmetric and Asymmetric Arm Design

Most two-post lifts lock you into one arm configuration. The Atlas 9KOHX gives you both. In symmetric mode, the arms extend evenly on both sides of the column — ideal for trucks and SUVs where the weight is distributed more evenly.

Switch to asymmetric mode and the vehicle sits further back, putting the door opening outside the columns. That means easier access to the interior, engine bay, and underbody without fighting the lift posts. The minimum arm height of 4 1/2″ gets under most low-profile cars without scraping.

Dual Direct-Drive Cylinders

The 9KOHX uses a dual direct-drive cylinder system instead of chains or screws. Direct drive means the hydraulic cylinder pushes the carriage straight up — no chains to stretch, no cables to adjust, no extra parts between the motor and the lift point.

Fewer moving parts translates to less maintenance and more consistent lifting over the life of the unit. The 220V single-phase motor runs on a standard 30 amp breaker, so most shops won’t need an electrical upgrade to install it.

The Right Lift for Your Shop

At 9,000 lbs, the Atlas 9KOHX sits in the sweet spot for shops that handle a mix of passenger vehicles and light trucks. The 110″ inside column width gives you room to work, and the 100″ symmetric drive-thru (90 1/2″ asymmetric) accommodates most wheelbases you’ll see.

The included 8-piece truck adapter set means you’re ready for trucks and SUVs right out of the crate — no extra purchases needed. Rubber guards on the carriages protect vehicle finishes during positioning.

Don’t wait — scroll back up and click the orange Add to Cart button to get this lift on its way to your shop.

Specs

Technical Specifications